if one rotor blade start turning then the other one. here is the stepĢ) disconnect the heli power source and wait for few second then reconnect it back ( before do this make sure you remote control calibration nod is all adjust to center.)ģ) slowly increase the speed of the two rotor blade and make sure they all starting to rotate at the same time. locate the "PROPORTIONAL" screw on the MIXER (RECEIVER), you need to turn the screw clockwise or anticlockwise to adjust it and please be gently. you need to adjust it to turn into same speed in order to make the heli stable. The heli keep yawing a side is because the two rotor turning in difference speed.
#DX6I TRANSMITTER WON'T MAP CORRECTLY WITH REALFLIGHT 7 FULL#
A full charged cycle will offers the Mini Lama with 8 to 12minutes flight The high -volume 7.4v 480mAh Li-Polymer battery pack is equipped with charging protection function. Customized fine adjustment makes your flight more perfect. It's possible to adjust the servo extent and the sensitivity of the build-in gyro in the 3-in-1 receiver circuit. The combination of prompt servos and 2XN30 strong magnetic motors ensures various flight courses. The Mini Lama is an optional model for the early beginner. *Servo & transmitter upgraded available to be MODEL HELICOPTERĬoaxial structure effectively offers stable flight and easy operation. *Co-axial structure enables it to fly stably indoors and outdoor. *Proportional system enables it to move up & down and stay at any height.
*Fly it forward backward turn left & right Hover trimming tab on controller stable hover and full 3-D flight Rear rotor stabilizer for controlled turnsħ. 3.7V 350mah lithium polymer battery is installed in the helicopter.Ħ. i wanna create a thread more formal one Ok now i have imported quite a few set of the heli to test out the market. i know there's oledy a thread for rc heli but tat one is jus asking for information and question. Hi everyone its me again this time i wanna open up a thread for R/C lovers.